Vw dune buggy plug and play wiring harness.14 inch chopped pan. Meyers manx etc.

Description

The original dune buggy brothers plug and play harness.
Soldered, shrink wrapped, vintage style harness wrap with all the dropouts where they need to be. Typically Terminated For VW Bug switches and equipment, labeled and ready to go.  Vintage style but with a modern ATO fuse block.
For YOUR Meyers manx vw kit car.  Also fits all the imitations...
Berrien, Acme, Skat-kat, Allison Daytona, Deserter, fiberfab, glitterbug, citation, kellison,  Mini t  Etc.
Custom built to your gauges/dash layout.  Wrapped in vintage factory style harness wrap.  Soldered, Terminated, and shrink wrapped connections. ALL CLEARLY LABELLED.
Made to order. There is a waiting list, so there is a lead time until delivery.
Approx 4 weeks.
I will need to know:
Hi beam Dimmer-
do you use an old school foot switch mounted by clutch pedal, or a VW turn signal that uses a soglenoid to shift between hi-beam and low-beam?
Reverse lights? Does your transaxle have a switch in the nose cone?
Old swing axle bugs usually have no provisions for a reverse switch. Lots of buggies run no reverse lights at all.
If you need wiring for a dash mounted toggle for reverse, specify!
Speedo type:
old VW with big numbers, or a newer 70’s style with integrated electronic fuel gauge?
Or aftermarket?
Column/ Turn lever.
Early 60’s style Vw column, GM type, aftermarket (empi) universal turn lever, toggle switch, *70’s vw column with ignition*.(please specify!)
Charging system- are you running An old generator with an external voltage regulator, or an alternator with an external voltage regulator,
or a newer “one wire” internally regulated alternator?
Do you have any Switches mounted left of the Steering column? Headlight switch?
Or is everything center pod mounted? It’s nice to have items drop out Of the harness in the correct place. Please list left to right.
Gauges, etc.
list ALL gauges and extras like: vdo electric fuel gauge, tach, temp gauge, whip (specify location), separate oil pressure gauge (specify mechanical or electric), radio, off road lights, fan...  Remember, A dune buggy should be simple so it won’t fail on you. Bruce calls them worry gauges.  Also: there’s only 6 tuses to work with.
Routing:
I typically build these to run down drivers side “harness tube”.
If you prefer down right side tube or on passenger floorboard (down the middle) please specify how you want it routed to the tail.
Some buggies like
the Mini t work better down the middle.
Thanks for looking
Here’s what is included 👇
You get SXL automotive wiring for hi-beam, low beam, running lights, turn signal lights, reverse lights, brake lights, Horn, dimmer switch, wiper switch, wiper motor, fuel sending unit, ignition switch, turn switch, horn switch, VW beetle speedometer (early or late with fuel gauge) headlight switch, gauges?, Dash accessories? (Radio), Coil, oil pressire switch, Alternator, Starter, and tag light. WITH GROUNDS NECESSARY FOR A FIBERGLASS CAR.  All basically wired like a vw beetle, but with a modern style 6 gang ATO fuse block with cap.
You will receive A finished, Ready to plug in, labeled, Wiring Harness- with a fuse block Hooked to it, ready to install in YOUR manx dune buggy. With installation instructions and technical support if necessary.
This listing is for a dune buggy wiring harness that fits YOUR 14 inch chopped pan (80 inch wheelbase) Dune buggy.
I can accomodate wiring for corvair running gear also.
Must have engine in rear.
Thanks -zippy-